Front
Assignable tally lamp
This is illuminated with the condition set in [MAIN MENU] → [SYSTEM CONFIG] → [TALLY ASSIGN].
The brightness can be switched with [MAIN MENU] → [TALLY BRIGHT] → [FRONT TALLY] → [HIGH]/[MID]/[LOW].
Red tally lamp
This is illuminated when the red tally signal is input.
The brightness can be switched with [MAIN MENU] → [TALLY BRIGHT] → [FRONT TALLY] → [HIGH]/[MID]/[LOW].
Green tally lamp
This is illuminated when the green tally signal is input.
The brightness can be switched with [MAIN MENU] → [TALLY BRIGHT] → [FRONT TALLY] → [HIGH]/[MID]/[LOW].
Yellow tally lamp
This is illuminated when the yellow tally signal is input.
The brightness can be switched with [MAIN MENU] → [TALLY BRIGHT] → [FRONT TALLY] → [HIGH]/[MID]/[LOW].
<EXT> lamp
This is illuminated when the lens extender is used.
The brightness can be switched with [MAIN MENU] → [TALLY BRIGHT] → [FRONT TALLY] → [HIGH]/[MID]/[LOW].
<ADJ> lamp
The lamp (green) is illuminated during adjustment.
This is illuminated when [FUNCTION] → [ASSIGN] is set to anything other than [UNDEF].
<POWER> lamp
The lamp (green) is illuminated when the power is turned on.
Turns off when set to [MAIN MENU] → [SYSTEM CONFIG] → [POWER LED] → [OFF1]/[OFF2].
<POWER> button
This is the button to turn on/off the power.
The power can be turned off by pressing this switch for two seconds or longer while the power is turned on.
<MENU> button
This switches on/off of the menu.
<SELECT> dial button
This is a dial button for menu screen operation.
The cursor will move down when the <SELECT> dial button is turned clockwise. The cursor will move up when turned counterclockwise.
To select a menu item, press the <SELECT> dial button.
Sets the function to assigned with [MAIN MENU] → [FUNCTION] → [ASSIGN].
<F1> to <F3> buttons
A function can be assigned to each button with [MAIN MENU] → [FUNCTION] → [FUNCTION1] to [FUNCTION3].
The function assigned to each is operated by pressing the button. For details, refer to [FUNCTION].
<FRICTION> knob
This adjusts the operation torque of panning.
The operation torque is increased when turned toward the <+> side and decreased when turned to the <−> side.
<BRIGHT> knob
This adjusts the brightness of the image.
<CONTRAST> knob
This adjusts the contrast of the image.
<PEAKING> knob
This adjusts the contour correction of the image.