Starting streaming with an operation from the application software

Select the [NETWORK] menu → [STREAMING] → [START TRIGGER] → [RECEIVER].

Specify the IP address and the path of the camera with the application software as follows, and start streaming.

rtsp://(IP address)/stream

Streaming with multicast

One streaming can be distributed to multiple receivers via supported router, etc., when the multicast function is used.

Select the [NETWORK] menu → [STREAMING] → [START TRIGGER] → [RECEIVER(MULTICAST)].

Select the [NETWORK] menu → [STREAMING], and specify [MULTICAST ADDRESS] and [MULTICAST PORT].

  • Set [MULTICAST ADDRESS] within following range.

    IPv4: 224.0.1.0 to 239.255.255.254

    IPv6: Multicast address starting with FF

  • Set [MULTICAST PORT] within the range of 1024 to 50000.

Specify the address of the camera and start streaming with the application software.