[SYSTEM MODE]

[FORMAT] cannot be selected right after the power is turned on, because boot of the camera is in progress.

This is not an error. Perform operation after a while.

Item

Description of settings

[FORMAT]

Sets the system format.

[2160/59.94p], [2160/29.97p], [2160/23.98p], [1080/59.94p-120fps], [1080/59.94p], [1080/29.97p], [1080/23.98p], [2160/50p], [2160/25p], [1080/50p-100fps], [1080/50p], [1080/25p]

  • Factory setting: [2160/59.94p]

[COLOR SETTING]

Sets the colors of entire camera system.

[NORMAL]: Enables fine image quality adjustments from the camera as with previous studio cameras.

[V-LOG]: Uses a gamma curve which can achieve a wide range of tone and exposure. Color grading will be necessary after shooting.

  • Factory setting: [NORMAL]

NOTE

  • [V-LOG] cannot be selected when [HDR SW] is [ON] or when [GAMUT] is other than [NORMAL].

[V-LOG PAINT SW]

Selects whether to make it possible to make settings in the [PAINT] menu when [COLOR SETTING] is [V-LOG].

[OFF], [ON]

  • Factory setting: [OFF]

NOTE

  • Even if [V-LOG PAINT SW] is set to [ON], the following functions cannot be set.
  • [MASTER PEDESTAL ABS DISP SWITCH] in [PEDESTAL]
  • [GAMMA], [GAMMA MODE SELECT], [MASTER GAMMA], [R GAMMA], [B GAMMA], and [INITIAL GAMMA] in [GAMMA/BLACK GAMMA]
  • [DRS] and [EFFECT DEPTH] in [DRS]
  • [PRESET MATRIX] in [LINEAR MATRIX]
  • [PRESET MATRIX] in [COLOR CORRECTION]

[COLORIMETRY]

Change the Y/C conversion coefficient.

[BT.709], [BT.2020]

  • Factory setting: [BT.709]

NOTE

  • Fixed to [BT.709] when [FORMAT] is other than [2160] or when [HDR SW] is [OFF].
  • The outputs of HD-SDI 1 and 2 become [BT.709] when each [HDR SW] is [OFF].

[GAMUT]

Change the color gamut.

[NORMAL], [WIDE_G], [WIDE_G2]

  • Factory setting: [NORMAL]

NOTE

  • Fixed to [NORMAL] when [FORMAT] is other than [2160].
  • The outputs of HD-SDI 1 and 2 are fixed to [NORMAL].

[HDR SW]

—

Enables/disables the HDR mode.

[OFF], [ON]

  • Factory setting: [OFF]

[HD_SDI1 OUT(HDR)]

Enables/disables the HDR signal from the <HD SDI1> terminal.

[OFF], [ON]

  • Factory setting: [OFF]

[HD_SDI2 OUT(HDR)]

Enables/disables the HDR signal from the <HD SDI2> terminal.

[OFF], [ON]

  • Factory setting: [OFF]

[SHOOTING MODE]

Sets the shooting mode.

[NORMAL], [HIGH SENS]

  • Factory setting: [NORMAL]

[SCAN MODE]

Selects the scan mode of the sensor.

[NORMAL], [LOW SKEW]

  • Factory setting: [NORMAL]

[CABLE CONNECTION]

Set the connection method used between the camera and CCU.

[HYBRID], [FIBER]

  • Factory setting: [HYBRID]