Right side

Eye cup (Attaching the eye cup)
Eye piece
Busy (active status indication) lamp (Removing SD memory cards)
Indicate the active status of the SD memory card, and is illuminated when the card is active.
SD memory card slot (Inserting SD memory cards)
This is the insertion slot for the SD memory card (optional). The SD memory card is used for recording/opening the camera setting menu, or uploading the metadata, etc.
NOTE
- Cautions when using SD memory cards
  - On the camera, use SD memory cards that conform to the SD standard, SDHC standard, or the SDXC standard.
  - MMC (Multi Media Card) cannot be used. (Bear in mind that taking pictures may no longer be possible if you use them.)
  - When using miniSD/microSD cards with the camera, always install the adaptor specially designed for miniSD/microSD cards. (The camera will not work properly if only the miniSD/microSD adaptor is installed. Make sure that the card has been inserted into the adaptor before use.)
  - Use of Panasonic SD memory cards and miniSD/microSD cards is recommended. Be sure to format cards on the camera before use.
  - Refer to our support desk at the following website for the latest information not included in these operating instructions.
    https://pro-av.panasonic.net/
  - SDHC memory cards are a standard that was established in 2006 by the SD Association for large-capacity memory cards that exceed 2 GB.
  - SDXC memory cards are a standard that was established in 2009 by the SD Association for large-capacity memory cards that exceed 32 GB.
Recording button (grip side) (Shooting)
Press this button to start recording. Press it again to stop recording.
Used for direct shooting in thumbnail mode.
Power switch (Preparation)
Switch on/off the power.
Microphone cable clamp (Attaching the front microphone)
Used for securing the microphone cable.
Pin holder
Attach the zoom ring pin which is removed from the camera.
Headphones terminal (Headphones)
This is the connecting terminal of headphones for audio monitor.
<AUDIO INPUT 2> terminal (XLR, 3-pin) (Using the external microphone and audio device)
Connect the audio equipment or the microphone.
<SDI OUT> terminal (TV/monitor)
This is the output terminal for HD/SD SDI signals.
<CAM REMOTE> terminal (Remote control)
Connect the remote control (optional) to control some functions remotely.
<FOCUS IRIS>: (3.5 mm mini jack) Control the focus operation and iris operation remotely.
<ZOOM S/S>: (2.5 mm mini jack) Control the zoom operation and start/stop operation of recording remotely.
Tripod holes
Attach the tripod. (bottom)
- Mounting hole size
  - 1/4-20 UNC (screw length 5.5 mm or shorter)
  - 3/8-16 UNC (screw length 5.5 mm or shorter)
<OPEN> button
Use this button when opening the cover of the <USB2.0 HOST> terminal at the bottom of the button.
<USB2.0 HOST> terminal (sub-host)
This is the USB terminal for maintenance.

Top of the page