Inserting a microP2 memory card

Open the card slot cover. (Fig. 1)

Insert a card into the card slot. (Fig. 2)

• Insert with the label side facing left.

• There are two microP2 memory card slots.

Confirm that the microP2 memory card access LED is lit in orange or green. (Fig. 3) (microP2 memory card access LED and status of microP2 memory card)

When two microP2 memory cards are inserted in the card slots, recording will be performed in order from the microP2 memory card with the smaller slot number. However, regardless of the slot number, if a microP2 memory card is inserted later, that microP2 memory card will be accessed later than the previously inserted microP2 memory cards.

• Example: When microP2 memory cards are inserted in two slots

  When microP2 memory cards are inserted into two slots, the cards are used as the microP2 memory cards in the order of slot numbers 1 → 2. However, if the microP2 memory card in the slot number 1 is removed and then inserted again, recording of the microP2 memory cards will take place in the order of slot numbers 2 → 1.

The microP2 memory card number to be recorded to is maintained even if the camera is turned off. When the camera is next turned on, recording can be continued to the same microP2 memory card as before the camera was turned off.

Close the card slot cover.