Ejecting the microP2 memory card

Open the card slot cover.

Remove the card.

Press in the microP2 memory card further into the camera and let go.
The microP2 memory card is released from the card slot, and the microP2 memory card can be removed.

NOTE

Do not eject the microP2 memory card while accessing or performing recognition after insertion (microP2 memory card access LED is flashing in orange). Doing so will cause a malfunction.
If the microP2 memory card is ejected while being accessed, [TURN POWER OFF] is displayed in the LCD monitor screen or the viewfinder screen, and warning is displayed in the tally lamp, etc. Also, all microP2 memory card access LEDs flash rapidly in orange. Turn off the power once. (Warning system)
The clip may become irregular in the microP2 memory card that was removed while being accessed. Check the clips and restore them, if required. (Restoring clips)
The format of the removed microP2 memory card is not guaranteed when the microP2 memory card is removed during the formatting. In this case, [TURN POWER OFF] is displayed on the LCD monitor screen or the viewfinder screen. Turn off the power once and then back on again, and reformat the microP2 memory card.
The microP2 memory card is not recognized and the microP2 memory card access LED will not illuminate if it is inserted in other slot during playback. Recognition of the microP2 memory card is started after the playback is completed.
Even if a microP2 memory card is inserted in a vacant slot during recording, the microP2 memory card may not be recognized immediately in the following conditions:
- Immediately after a pre-recording
- Immediately after a recording slot is switched
The microP2 memory card access LED can be set to constantly off in the main menu → [OTHER FUNCTIONS] → [ACCESS LED]. In this case, turn off the power before removing the card, or after the card is inserted or after operation (recording, playback, etc.) has stopped, and wait for the charging to complete before removing the card.

Top of the page