[OUTPUT SEL]

Sets the setting regarding output from the <SDI OUT> and the <HDMI OUT> terminals.

Item

Description of settings

[SDI OUT]

Selects video output from the <SDI OUT> terminal.

[ON]: Outputs video.

[OFF]: Does not output video.

  • Factory setting: [OFF]

[SDI&HDMI SELECT]

Selects output signals from the <SDI OUT> terminal and <HDMI OUT> terminal.

[SYSTEM MODE]: Follows the setting in [SYSTEM MODE] → [LINE&FREQ].

[1080i]: Converts into interlaced signals and outputs them when [1080-59.94P] or [1080-50P] is selected in [SYSTEM MODE] → [LINE&FREQ]. This cannot be selected when other settings are made.

[DOWNCON]: Down converts to SD signal and outputs.

  • Factory setting: [SYSTEM MODE]

[3G-SDI OUT]

Selects 1080P signals of the HD SDI output in 1080P mode.

[LEVEL-A]: Selects the LEVEL-A method.

[LEVEL-B]: Selects the LEVEL-B DL method.

  • Factory setting: [LEVEL-B]

[SDI OUT CHAR]

Selects whether to superimpose characters on <SDI OUT> terminal output images.

[ON]: Superimposes.

[OFF]: Does not superimpose.

  • Factory setting: [OFF]

[SDI EDH]

Selects whether to superimpose EDH when output from the <SDI OUT> terminal is SD signal (480i and 576i).

[ON]: Superimposes.

[OFF]: Does not superimpose.

  • Factory setting: [ON]

[HD SDI REMOTE]

Sets whether to use the control function of recording operation for an external device (such as a recorder) connected to the <SDI OUT> terminal at HD SDI output.

[ON]: Controls the recording operation of the external device.

[OFF]: Does not control the recording operation of the external device.

  • Factory setting: [OFF]

[DOWNCON MODE]

Selects the mode of the down convertor output signal from the <SDI OUT> terminal when it is in the HD mode (1080P, 1080i, or 720P).

[SIDE CROP], [LETTER BOX], [SQUEEZE]

  • Factory setting: [LETTER BOX]

[DOWNCON SETTING]

[DETAIL]

Turns detail function for the down converter output signal [ON]/[OFF].

[ON], [OFF]

The down converter output signal contains detail components set during HD signal processing.

This setting superimposes the detail components exclusive to down converter output to that signal.

  • Factory setting: [ON]

[H.DTL LEVEL]

Sets horizontal detail correction level for the down converter output signal.

[0]…[31]

  • Factory setting: [8]

[V.DTL LEVEL]

Sets vertical detail correction level for the down converter output signal.

[0]…[31]

  • Factory setting: [4]

[DTL CORING]

Sets the detail noise removal level.

[0]…[15]

  • Factory setting: [1]

[H.DTL FREQ]

Selects the horizontal detail frequency.

[2.5MHz], [3MHz], [3.5MHz], [4MHz], [4.5MHz]

  • Factory setting: [3.5MHz]