Connecting to a computer in the USB device mode

The microP2 memory card inserted in the camera can be used as a mass storage by connecting to a computer via USB 2.0.

Connecting to a computer

co_body_connect_USB2.0
co_osd_usb_device_mode

Connect the USB cable to the <USB2.0 DEVICE> terminal (device). (Fig. 1)

Set the main menu → [USB SETUP] → [USB MODE] to [ON]. (Fig. 2)

During USB connection, [USB DEVICE CONNECTED] is displayed in the center of the viewfinder or LCD monitor.

If it is not connected properly, [USB DEVICE DISCONNECTED] is displayed.

Exit the USB device mode.

There are three methods:

  • Turn the power switch of the camera to <OFF>.

  • Press the <EXIT> button.

    While in USB device mode, [Push EXIT to Return to CAMERA MODE] is displayed at the lower of the LCD monitor or viewfinder or screen.

  • Press the USER button to which [USB MODE] has been assigned.

Returns to camera shooting status in approx. five seconds when the USB device mode ends.