- Top
- Picture monitor (PM)
- Information display
- Warning displays
The warning information is displayed when trouble is detected in the unit, camera, or optical fiber multi cable.
- Warning information displayed is cleared when the status returns to normal.
- To manually clear the warning information display, hold down the [CHARA] button of the ROP.
Information displayed
Display item |
Description |
CAM RCV LVL NG |
The level of the optical signal received by the camera is low. |
CCU RCV LVL NG |
The level of the optical signal received by the CCU is low. |
CAM FAN NG |
Trouble with the cooling fan of the camera. |
CCU FAN NG |
Trouble with the cooling fan of the CCU. |
CAM HIGH TEMP |
The temperature of the camera is abnormally high. |
CCU HIGH TEMP |
The temperature of the CCU is abnormally high. If you continue operation even with the message displayed, power supply to the camera may stop as a protective measure. |
CAM OVER TEMP |
Due to overheating, the camera turned OFF automatically as a protective measure. |
OVER LOAD |
The power supply circuit load to the camera exceeded 90%. |
POWER CONT ERROR |
Trouble with the power supply circuit to the camera. |
CABLE OPEN |
The optical fiber multi cable is not connected. |
CABLE SHORT |
Power supply to the camera will stop as a protective measure. Turn the unit off immediately, and determine and resolve the problem before turning it back on.
|
FORMAT NG |
The CAM mode and CCU mode do not match. |
During data transfer (CAM←→ROP) |
Data transfer between the camera and ROP is in progress. |