SETUP

This is the selection screen for the SETUP menu.

___ indicates factory default settings.

Item

Setting value

Setting details

IRIS SCALE

FULL

2STOP

Set the IRIS display range of the status display screen.

CABLE CONNECTION

HYBRID

FIBER

Sets the cable used to connect the camera.

HYBRID

Select this when connecting the camera using an optical fiber multi cable.

FIBER

Select this when connecting the camera using only optical fiber.

  • When [FIBER] is selected, power will not be supplied to the camera. In addition, the "OPEN" and "SHORT" errors will not be displayed.

USER BUTTON1

NONE

CHARA

BARS

Sets the function to be assigned to the [USER1] button on the front panel.

NONE

No assignment

CHARA

Character display, operation

BARS

Color bar ON/OFF

USER BUTTON2

NONE

CHARA

MENU/USER1 LOCK

BARS

Sets the function to be assigned to the [USER2] button on the front panel.

NONE

No assignment

CHARA

Character display, operation

MENU/USER1 LOCK

Invalidate [MENU] button, [USER1] button

(Function is assigned, but nothing happens when button pressed.)

BARS

Color bar ON/OFF

TALLY

MAKE

V

Select the input format for the TALLY signal.

MAKE

When the TALLY IN H terminal and the TALLY IN C terminal are OPEN, then TALLY=OFF. When they are MAKE, then TALLY=ON.

  • The TALLY IN H terminal is internally pulled up to +5 V with a 2.2 K resistor through a protective diode. The maximum current is 20 mA or less.

V

When voltage is applied to the TALLY IN H terminal, TALLY is ON, and when voltage is not applied, TALLY is OFF. Connect TALLY IN C to GND.

  • A resistor of about 12.4 kΩ is inserted between TALLY IN H and TALLY IN C. The maximum voltage that can be applied is 24 V, and the maximum current is 20 mA.