Ejecting the memory card

Open the card slot cover.

Remove the card.

P2 cards
- Lift the eject button (Fig. 1), and press in. (Fig. 2)
SD memory cards
- Press in the SD memory card further into the camera and let go.
- The SD memory card is released from the card slot, and it can be removed.

NOTE

Do not remove the P2 card after inserting it, while it is being accessed, or being detected (card access LED flashing in orange). Otherwise, it may result in a malfunction.
[TURN POWER OFF] is displayed in the viewfinder screen or the center of the control panel or in the warning message area at the top left of each output indicator, and a warning is displayed with the warning lamp, etc., when the P2 card being accessed is removed. Also, all card access LEDs flash rapidly in orange. Turn off the power. (Warning system)
If the P2 card is removed while being accessed, clips on it may become irregular. Check the clips and restore them, if required.
If the P2 card being formatted is removed, formatting of the P2 card is not guaranteed. [TURN POWER OFF] is also displayed in the viewfinder screen or the center of the control panel or in the warning message area at the top left of each output indicator at this time. Turn off the power and then back on again, and reformat the P2 card.