[THUMBNAIL] menu

Performs confirmation or deleting of the recording clip.

This menu can be set when the thumbnail screen is displayed.

[PLAYBACK]

Sets the playback of recorded clips.

The clip selection is generally [ALL SLOT] when toggling the thumbnail screen from the camera image screen.

[CLIP SEL]

Selects a clip to be displayed on the thumbnail screen.

[ALL SLOT]

Displays the clips recorded on all the memory cards in each card slot.

[SLOT1]

Displays only the clips recorded on the memory card in card slot 1.

[SLOT2]

Displays only the clips recorded on the memory card in card slot 2.

[SAME FORMAT]

Displays only the clips recorded in the same format as the system format.

Clips recorded in the same format means that each item of [FREQUENCY], [FILE FORMAT], [REC FORMAT], and [AUDIO SAMPLE RES.] in the [SYSTEM] menu matches the current setting status.

[MARKED]

Displays only the clips with a shot mark attached.

(Factory setting: [ALL SLOT])

[RESUME PLAY]

Select if the playback is to start from the position the playback has stopped or not.

[ON]

Plays back from the position where playback has stopped.

[OFF]

Always starts the playback from the beginning of the clip.

(Factory setting: [OFF])

[CLIP]

The clip can be protected or copied to a different memory card.

[PROTECT]

[SELECT]

Protect the clip so it is not mistakenly deleted.

Select the clip to protect, and set the protect.

[DELETE]

[ALL]

Deletes all the clips displayed in the thumbnail screen.

The clip that is not displayed in the thumbnail screen is not deleted.

[SELECT]

Select the clip to delete, and delete it.

[COPY]

[ALL]

Copies all clips to a different memory card.

[SELECT]

Selects the clip to copy, and copies the clip to a different memory card.

[REPAIR]

Repairs a clip displaying imageicon_ng_clip_yellow caused by the sudden power loss, etc., during recording in P2 format.

[RE-CONNECT]

[SELECT]

While recording in P2 format, a clip recorded over multiple microP2 cards may not be recognized as a continuous clip, and may display imageicon_clip_incomplete.

Restores as a continuous clip by selecting the clips to re-connect.

[INFORMATION]

Displays the detailed information of the clip.

[DISPLAY]

Sets the display of the thumbnail screen.

[DATA]

Selects the content to be displayed in the time code display area.

[START TC]

Displays the time code value at the start of the recording.

[CLIP NAME]

Displays clip names.

(Factory setting: [START TC])