Setting for each protocol and starting the streaming

RTMP(S)

Select the [NETWORK] menu → [STREAMING] → [STREAMING PROTOCOL] → [RTMP(S)].

Set the destination.

For details of setting the streaming destination, refer to “Setting of the destination”.

Select the [NETWORK] menu → [STREAMING] → [START] → [ON].

If the camera is connected to the transmission destination through a network, the camera starts the transmission of streaming video.

  • To stop the transmission of the streaming image, select the [NETWORK] menu → [STREAMING] → [START] → [OFF].

RTSP

Start the streaming with an operation of the application software or device at the receiving side (referred to as “receiving side” hereinafter).

Select the [NETWORK] menu → [STREAMING] → [STREAMING PROTOCOL] → [RTSP].

Set the standby port with the [NETWORK] menu → [STREAMING] → [RTSP SETTING] → [PORT] on the camera if required.

Specify the IP address and the path of the camera as following on the receiving side, and start streaming.

rtsp://(IP address):(Port number)/stream

SRT client

Select the [NETWORK] menu → [STREAMING] → [STREAMING PROTOCOL] → [SRT CLIENT].

Set the destination.

For details of setting the streaming destination, refer to “Setting of the destination”.

Select the [NETWORK] menu → [STREAMING] → [START] → [ON].

If the camera is connected to the transmission destination through a network, the camera starts the transmission of streaming video.

  • To stop the transmission of the streaming image, select the [NETWORK] menu → [STREAMING] → [START] → [OFF].

SRT listener

Start the streaming with an operation of the application software or device at the receiving side (referred to as “receiving side” hereinafter).

Select the [NETWORK] menu → [STREAMING] → [STREAMING PROTOCOL] → [SRT LISTENER].

Set following items with the [NETWORK] menu → [STREAMING] → [SRT SETTING] on the camera.

  • Set the standby port with [PORT].

  • If the streaming data is to be encrypted, select the encryption method in [ENCRYPTION], and enter the passphrase in [PASSPHRASE].

Specify the IP address and the stream ID of the camera as following on the receiving side, and start streaming.

srt://(IP address):(Port number)

  • The stream ID is fixed to following value in the SRT listener mode.

    #!::m=publish,r=PanasonicStream