[SYSTEM MODE]

[FORMAT] cannot be selected right after the power is turned on, because boot of the camera is in progress.

This is not an error. Perform operation after a while.

Item

Description of settings

[FORMAT]

Sets the system format.

[2160/59.94p], [2160/29.97p], [2160/23.98p], [1080/59.94p], [1080/29.97p], [1080/23.98p], [2160/50p], [2160/25p], [1080/50p], [1080/25p]

  • Factory setting: [1080/59.94p]

[COLORIMETRY]

Change the Y/C conversion coefficient.

[BT.709], [BT.2020]

  • Factory setting: [BT.709]

NOTE

  • Fixed to [BT.709] when [FORMAT] is other than [2160].
  • The outputs of HD-SDI 1 and 2 become [BT.709] when each [HDR SW] is [OFF].

[GAMUT]

Change the color gamut.

[NORMAL], [WIDE_G]

  • Factory setting: [NORMAL]

NOTE

  • Fixed to [NORMAL] when [FORMAT] is other than [2160].
  • The outputs of HD-SDI 1 and 2 are fixed to [NORMAL].

[HDR SW]

—

Enables/disables the HDR mode.

[OFF], [ON]

  • Factory setting: [OFF]

[HD_SDI1 OUT(HDR)]

Enables/disables the HDR signal from the <HD SDI1> terminal.

[OFF], [ON]

  • Factory setting: [OFF]

[HD_SDI2 OUT(HDR)]

Enables/disables the HDR signal from the <HD SDI2> terminal.

[OFF], [ON]

  • Factory setting: [OFF]

[SHOOTING MODE]

Sets the shooting mode.

[NORMAL], [HIGH SENS]

  • Factory setting: [NORMAL]

[CABLE CONNECTION]

Set the connection method used between the camera and CCU.

[HYBRID], [FIBER]

  • Factory setting: [HYBRID]