Shooting and recording/playback functions section (Recording unit)

body_parts_rec_2
  1. <REC> button

    Recording is started by pressing the <REC> button. Recording is stopped by pressing this button again.

    Performs the same operation as the <VTR> button of the lens to be attached.

  2. Card access lamp 1/card access lamp 2/card access lamp 3

    Indicates the access status of recording and playback of the memory card.

  3. Card slot 1

    This is a card slot only for expressP2 card.

  4. <USB DEVICE> terminal

    In the USB device mode, the camera can be connected to the computer by the USB type C cable to transfer data.In this case, recording playback operations and camera shooting are not possible.

  5. Card slot 2/card slot 3

    These are card slots for microP2 card and SD card.

  6. <REV (%)> button

    It will perform fast-reverse playback when this is pressed during playback.

    It will playback from the start of the clip when this is pressed while paused.

  7. <STOP (()> button

    Press this button to stop playback.

  8. <FWD ())> button

    It will perform fast playback when this is pressed during playback.

    It will play back from the start of the next clip when this is pressed while paused during a playback.

  9. <PLAY/PAUSE (=/&)> button

    Plays back a clip.

    Playback is paused when this is pressed during the playback.

  10. <SDI OUT 2 CHARACTER> switch

    Controls the superimposing of characters into the video output from the <SDI OUT2> terminal.

    Controls the superimposing of characters into the video output from the <HDMI> terminal when the [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [SIGNAL SEL] → [SDI OUT2] is set.

    <ON>: Superimposes the character.

    <OFF>: Does not superimpose the character.

  11. <USB2.0 HOST> terminal

    Can connect via wireless LAN when the wireless module (optional) compatible to camera is mounted.

  12. <HDMI> terminal

    This is the output terminal for videos.

    Output signal can be switched with the [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [SIGNAL SEL].

    [SDI OUT1(2160p)]: Follows the setting of the output signal from the <SDI OUT1> terminal.

    [SDI OUT2]: Follows the setting of the output signal from the <SDI OUT2> terminal.

    Setting for superimposing of characters can be switched in the [VIDEO OUT/LCD/VF] menu → [HDMI OUT] → [SIGNAL SEL].

  13. <LAN> terminal

    Connects the 1000BASE-T/100BASE-TX/10BASE-T LAN cable.

    Use Category 7 LAN cable.

  14. <SDI OUT1> terminal

    This is the output terminal only for SDI.

    Select an output signal in the [VIDEO OUT/LCD/VF] menu → [SDI OUT1] → [OUT FORMAT].

    Superimposing of characters is set in the [VIDEO OUT/LCD/VF] menu → [SDI OUT1] → [SDI OUT CHAR].

  15. <SDI OUT2> terminal

    This is the video output terminal for the monitor.

    Select an output signal in the [VIDEO OUT/LCD/VF] menu → [SDI OUT2] → [OUT FORMAT].

    Superimposing of characters can be set with the <SDI OUT 2 CHARACTER> switch independently of the <SDI OUT1> terminal.