Connecting to a computer in the card reader mode

Connect the camera to a computer via the USB type C cable to use the camera as a card reader for the memory card.

Connect with following procedure.

Connect the USB cable to the <USB DEVICE> terminal. (Fig. 1)

Select the [OTHERS] menu → [USB DEVICE] → [CARD READER MODE].

Connection is completed when [USB connected. Please operate via PC.] is displayed.

If the USB connection is being moved or it is not connected properly, [Connect this unit to PC using USB cable.] is displayed.

NOTE

A USB type C cable is not supplied with this camera. Prepare a commercial USB type C cable (double-shielded for noise suppression).
Using a USB cable 1.5 m or shorter is recommended.
When connecting the camera to a computer via USB, ensure that no other device is connected to the computer via USB.
Do not remove the memory card when connecting the camera via USB.
The card access lamp while connected to USB will turn off unless accessing.
When the camera is operating in the card reader mode, camera shooting, recording/playback operation, or thumbnail operation of the clip is not allowed.
When the camera is operating in the card reader mode, the remaining capacity and status of the memory card are not displayed. Also, video/audio cannot be output or displayed.
The LCD monitor lights up by touching the monitor if it has turned out to save energy.