• Top
• Maintenance
• Warning system
• Warning list

Warning list

1. System error

   Status display	Does not display.
   Warning lamp	Flashes four times per second.
   Tally lamp	Flashes four times per second.
   Card access lamp	All card access lamps flash four times per second in orange.
   Viewfinder	[SYSTEM ERROR] is displayed.
   Alarm	Sounds continuously.
   Warning content	Reference signal error or communication error.
   Recording or playback operation	The current operation will stop.
   Action to take	Consult your dealer.

2. Card removal error

   Status display	Does not display.
   Warning lamp	Flashes four times per second.
   Tally lamp	Flashes four times per second.
   Card access lamp	All card access lamps flash four times per second in orange.
   Viewfinder	[TURN POWER OFF] is displayed.
   Alarm	Sounds continuously.
   Warning content	An error occurred in the camera because the expressP2 card being accessed was removed.
   Recording or playback operation	The current operation will stop.
   Action to take	Follow the message to turn the power off once and turn the power on again. Ensure that there is no error in the clips on the ejected card, and repair the clips as necessary.

3. Battery end (low voltage input)

   Status display	Seven battery charge level bars flash.
   Warning lamp	Lights.
   Tally lamp	Flashes four times per second.
   Card access lamp	All card access lamps flash four times per second in orange.
   Viewfinder	The [BATT] lamp is illuminated if the viewfinder has the [BATT] lamp. [EMP] flashes in the battery charge level display. ([%] flashes for batteries with information about its remaining capacity.)
   Alarm	Sounds continuously.
   Warning content	The battery has run out.
   Recording or playback operation	The current operation will stop. The power is turned off in approximately five seconds.
   Action to take	Change the batteries.

4. High temperature error

   Status display	Does not display.
   Warning lamp	Flashes four times per second.
   Tally lamp	Flashes four times per second.
   Card access lamp	All card access lamps flash four times per second in orange.
   Viewfinder	[HIGH TEMPERATURE] is displayed.
   Alarm	Sounds continuously.
   Warning content	The internal temperature of the camera has risen exceeding the expectation.
   Recording or playback operation	The current operation will stop. The power is turned off in approximately five seconds.
   Action to take	Turn on the power again and confirm the recording by playing it back. If the problem persists, consult the dealer.

5. Card end

   Status display	Seven remaining memory card capacity level bars flash.
   Warning lamp	Lights.
   Tally lamp	Flashes four times per second.
   Card access lamp	All card access lamps flash four times per second in orange.
   Viewfinder	[END] is displayed in the remaining memory card capacity display.
   Alarm	Sounds continuously.
   Warning content	There is no more remaining memory card capacity.
   Recording or playback operation	Recording will stop.
   Action to take	Delete clips in the memory card or insert a new memory card.

6. Recording error

   Status display	Does not display.
   Warning lamp	Flashes four times per second.
   Tally lamp	Flashes four times per second.
   Card access lamp	All card access lamps flash four times per second in orange.
   Viewfinder	[REC WARNING] is displayed. [REC WARNING]/[<OVER MAX NUM. OF CLIPS>] is displayed when you try to record exceeding the limit for number of clips. [TEMPORARY PAUSE]/[IRREGULAR SIG] is displayed when the genlock reference signal is not correctly received.
   Alarm	Sounds four times per second.
   Warning content	This is a recording or recording circuit setting error.
   Recording or playback operation	Recording will stop. When the reference signal for genlock is not correctly received, pause the recording, and resume the recording when the signal returns to normal.
   Action to take	Start recording again. Or, turn the power off once and then start recording again. To record exceeding the maximum numbers of the clips, replace the memory card or delete unnecessary clips.

7. Card error

   Status display	Does not display.
   Warning lamp	Flashes four times per second when occurring during recording. It does not illuminate when it occurs during playback.
   Tally lamp	Flashes four times per second when occurring during recording. It does not illuminate when it occurs during playback.
   Card access lamp	All card access lamps flash four times per second in orange when occurring during recording.
   Viewfinder	Displays [CARD ERROR <SLOT 1>] (corresponding card slot number is displayed).
   Alarm	Sounds four times per second when occurring during recording. It does not sound when it occurs during playback.
   Warning content	A memory card error occurred during recording or playback.
   Recording or playback operation	The current operation will stop. The memory card with the error is write-protected after it is stopped.
   Action to take	Replace the memory card.

8. Reduced wireless audio reception

   Status display	Does not display.
   Warning lamp	Flashes four times per second. (When idle or during recording)
   Tally lamp	Flashes four times per second while recording is continued.
   Viewfinder	[WIRELESS RF] is displayed.
   Alarm	Sounds four times per second while recording is continued.
   Warning content	The error indicates poor wireless audio reception conditions.
   Recording or playback operation	The current operation will continue.
   Action to take	Check the microphone power supply and the reception status of the receiver.

9. Battery near end

   Status display	One battery charge level bar flashes.
   Warning lamp	Flashes once per second.
   Tally lamp	Flashes once per second.
   Viewfinder	The [BATT] lamp flashes once per second if the viewfinder has the [BATT] lamp. ([%] indication flashes if the battery has information of remaining capacity.)
   Alarm	Sounds four times per second.
   Warning content	The battery is about to run out.
   Recording or playback operation	The current operation will continue.
   Action to take	Change the batteries as needed.

10. Memory card recording near end

    Status display	One remaining memory card capacity level bar flashes.
    Warning lamp	Flashes once per second while recording is continued.
    Tally lamp	Flashes once per second while recording is continued.
    Viewfinder	The remaining memory card capacity indicator flashes.
    Alarm	Sounds once per second while recording is continued.
    Warning content	The remaining memory card capacity totals 2 minutes or less.
    Recording or playback operation	The current operation will continue.
    Action to take	Change the memory card or insert an additional card as needed.