Starting streaming with an operation on the camera

Select the [NETWORK] menu → [STREAMING] → [START TRIGGER] → [CAMERA].

Set the destination.

Select the [NETWORK] menu → [STREAMING] → [START] → [ON].

If the camera is connected to the transmission destination through a network, the camera starts the transmission of streaming video.

NOTE

When the streaming cannot be started due to reasons such as the network is not connected, the [NETWORK] menu → [STREAMING] → [START] cannot be selected.
Starting/stopping of the streaming from the camera can be assigned to the USER button. (Assigning function to the USER buttons)
Streaming cannot be started by pressing the USER button when the menu or the thumbnail screen is displayed.
Only RTMP and RTMPS are available when starting streaming with an operation from the camera. In such case, IPv6 cannot be used.
For settings such as URL, refer to the manual for each streaming service.
Streaming may not be possible depending on the operating condition of the streaming service.
Streaming stops when performing operations such as displaying the thumbnail screen or playing back clips on the camera.
Streaming may stop when the date/time is set while streaming.

Setting the destination for streaming in the menu of the camera

Select the [NETWORK] menu → [STREAMING] → [CONNECTION INFO.] → [MEMORY].

Enter the destination URL in the [NETWORK] menu → [STREAMING] → [RECEIVER URL].

Enter the destination URL in following format.
- rtmp://(server URL):(port number)/(path)/(stream key)
- rtmps://(server URL):(port number)/(path)/(stream key)

Insert the memory card with the destination information saved into the card slot selected in the [OTHERS] menu → [FILE] → [SLOT FOR LOAD/SAVE].

Select the [NETWORK] menu → [STREAMING] → [CONNECTION INFO.] → [SD CARD].

Destination information can be saved and loaded between the menu of the camera and the memory card.

Select the [NETWORK] menu → [STREAMING] → [CLEAR (MEMORY)].

Select the [NETWORK] menu → [STREAMING] → [START] → [OFF].