- Top
- Preparation
- Preparing the memory card
- Status of the card access lamp and memory card
Status of the card access lamp and memory card
Card access lamp | Memory card status | |
---|---|---|
Orange (illuminated) |
Recording target |
Both loading/writing are permitted. Current recording target. |
Green (illuminated) |
Recording possible |
Both loading/writing are permitted. |
Orange (flashing) |
Accessing card |
Loading/writing are currently being performed. |
Orange (rapidly flashing) |
Recognizing memory card |
The memory card is being recognized. |
Error |
An error has occurred. This will flash even if the memory card is not inserted when an error has occurred. | |
Green (slowly flashing) |
No remaining recording capacity |
No recording capacity left on the memory card. Only loading is possible. |
Write-protected |
The write-protection switch of the memory card is set to the LOCK side. | |
Recording not possible |
It cannot record with the recording format that is currently set. Change the recording format or use a memory card compatible with the recording format to record. | |
Off |
No memory card inserted |
A memory card has not been inserted. |
Illegal format |
It is not the correct format. Reformat the card. | |
Card not supported |
This is a card that cannot be used with the camera, such as MMC (Multi Media Card). | |
Setting to [NETWORK] menu → [NETWORK FUNC] → [NDI|HX] |
Cannot record and play back. The functions other than recording and playback (loading of the scene file, etc.) can be used. | |
During card reader mode |
The card 1 access lamp/card 2 access lamp turns off when not accessing. |