Wireless LAN settings

This is the setting to connect with the iPad or the Android terminal directly or to connect to the wireless access point via wireless LAN.

Direct connection ([DIRECT])

This is the setting to connect the camera to the iPad/Android terminal directly.

The camera may restart if necessary when the setting is changed.

Select the [NETWORK] menu → [DEVICE SEL] → [WLAN].

Select the [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [DIRECT].

In the [NETWORK] menu → [WLAN PROPERTY], set each item as necessary.

Select the SSID of the camera from the SSID list in the iPad/Android terminal, and enter the password (encryption key).

Display the wireless access point list screen in wireless LAN setting, and select SSID of the camera.

  • Factory setting: [AG-CX350E]

When the password confirmation screen appears, enter the password (encryption key).

For details, refer to the operating instruction of the iPad/Android terminal.

  • Factory setting: [01234567890123456789abcdef]

Close the menu or return to the level of the [NETWORK] menu.

Check the network connection.

Once connected, imageicon_rop_not_connect_1 is displayed on the screen of the camera.

Connecting to the wireless access point ([INFRA(SELECT)]/[INFRA(MANUAL)])

This is the setting to connect the camera to a wireless access point.

When connecting by searching the wireless access point (SSID)

Select the [NETWORK] menu → [DEVICE SEL] → [WLAN].

Select the [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [INFRA(SELECT)].

In the [NETWORK] menu → [WLAN PROPERTY], set each item as necessary.

Select the SSID of the searched wireless access point.

Setting is completed when the [ENCRYPT KEY] (encryption key, password) is not set.

If the [ENCRYPT KEY] is set, enter the password, and select [Enter].

Close the menu or return to the level of the [NETWORK] menu.

Check the network connection.

Once connected, imageicon_rop_not_connect_1 is displayed on the screen of the camera.

When entering the wireless access point (SSID) manually

Select the [NETWORK] menu → [DEVICE SEL] → [WLAN].

Select the [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [INFRA(MANUAL)].

In the [NETWORK] menu → [WLAN PROPERTY], set each item as necessary.

In the [NETWORK] menu → [WLAN PROPERTY] → [SSID], enter the SSID of the wireless access point to connect.

Setting is completed when the [ENCRYPT KEY] (encryption key, password) is not set.

If the [ENCRYPT KEY] is set, enter the password, and select [Enter].

Close the menu or return to the level of the [NETWORK] menu.

Check the network connection.

Once connected, imageicon_rop_not_connect_1 is displayed on the screen of the camera.