Rear panel 2

illust_rear_panel_2.svg

1

[LAN] connector

It is the LAN connector (RJ45) for connecting the ROP (AK-HRP1000 / AK-HRP1005 / AK-HRP1010 / AK-HRP1015 / AK-HRP250) with an IP connection.

Use a switch hub and connect the devices with a 10BASE-T/100BASE-TX straight cable. This connector is for connecting a personal computer when configuring Web settings.

52143.png “Web Screen”

2

[AUX] connector

This connector is used for controlling a waveform monitor and external systems (down-convert system, MIC gain selection, alarm output, or tally output).

3

[TRUNK] connector

This connector provides two systems for 2-way communication of camera trunk data (RS-422 and RS-232C).

4

[COMMUNICATION] connector

This connector is for connecting the intercom signals and tally signals to the external system.

5

[ROP] connector

This connector is for connecting a ROP (sold separately).

6

[MSU] connector

This connector is for connecting an MSU (sold separately).

7

[MIC1] and [MIC2] connectors

These connectors are for outputting the analog signals of microphones 1 and 2 of the camera.

The microphone level is 0 dBm/600 Ω.

8

[CAMERA] connector

This connector is for connecting the optical fiber multi cable (sold separately).

9

Cooling fan

This is the unit's cooling fan.

10

AC power socket

This socket is for inputting AC power.

Connect the supplied power cable, and use a 3-prong outlet and ground the unit properly.

11

[SIGNAL GND] terminal

Connect this to the system ground.