OUT FORMAT(HD)

SDI OUT1-4

SDI OUT1

3G

HD

Set the format of the signals to be output from [1] to [4] of the [UHD/HS/HD SDI OUT] connectors.

“Output selection conditions”

The settings of [SDI OUT5] and [SDI OUT6] are linked and change together.

[SFP+ OUT] is displayed when a MoIP board (AK-NP600) is connected.
[SFP+ OUT] follows the [SDI OUT1-4] setting in the same way as [SDI OUT 1/2/3/4].

Output from SFP+ is enabled only when CCU MODE is set to [1080/59.94P], [720/59.94p], [1080/50p], or [720/50p].

SDI OUT1-4

SDI OUT2

SDI OUT1-4

SDI OUT3

SDI OUT1-4

SDI OUT4

SDI OUT1-4

SFP+ OUT

SDI OUT5&6

3G
HD
PsF
trueP
OVER(3G)

Set the format of the signals to be output from [5] to [7] of the [HD SDI OUT] connectors.

The settings of [SDI OUT5] and [SDI OUT6] are linked and change together.

When [CCU MODE] is [1080/29.97PsF], [1080/23.98PsF] or [1080/25PsF]:

PsF/trueP/OVER(3G)

SDI OUT5&6 and SDI OUT7 are set to the same signal. (They cannot be set individually.)

When [CCU MODE] is other than [1080/29.97PsF], [1080/23.98PsF], [1080/25PsF]:

3G/HD

“Output selection conditions”

SDI OUT8

HD
PsF

Set the format of the signals to be output from [8/PM] of the [HD SDI OUT] connector.

When [CCU MODE] is [1080/29.97PsF], [1080/23.98PsF] or [1080/25PsF]:

PsF (fixed)

When [CCU MODE] is other than [1080/29.97PsF], [1080/23.98PsF], [1080/25PsF]:

HD (fixed)

“Output selection conditions”

SDI OUT8

NORMAL/PM

PM

NORMAL

Set the signal to be output from [8/PM] of the [HD SDI OUT] connector.

Can only be set to PM when using a MoIP board (AK-NP600).

PM :

Output the picture monitor images.

NORMAL :

Output the main line images.

3G SDI

LEVEL-A

LEVEL-B

Set the output format for 3G output.