Transferring recorded clips automatically (automatic transfer mode)
Establish the network connection between the camera and a server device.
Perform the setting referring to “FTP client function setting ”.
Set the camera’s main menu → [NETWORK SETUP] → [FTP CLIENT SERVICE] → [REC DURING UPLOAD] to [ENABLE].
Select the type of the clip to upload in the camera’s main menu → [NETWORK SETUP] → [FTP CLIENT SERVICE] → [AUTO UPLOAD].
[REC CLIP(PROXY)]: Upload target is proxy data of recorded clips.
[REC CLIP]: Upload target is recorded clips (main recording data and proxy data).
[DISABLE]: Recorded clips are not upload targets.
Shoot.
Clips are registered in the upload list immediately after recording is stopped, and then recorded clips are automatically transferred.
The viewfinder or LCD monitor shows the operation status of the rec during upload function. In addition, the thumbnail screen shows the operation status of the rec during upload function and the transfer status of clips.
NOTE
Uploading of the clip will start after the rec during upload function is enabled. To prevent the upload error, do not remove the card from the P2 memory card slot and the microP2 memory card slot until the upload is completed.
Up to 100 clips can be registered in the upload list for the upload of clips. Clips exceeding 100, excluding the uploaded clips and clips failed to upload cannot be registered.
While recording is stopped, you can add recorded clips to transfer. Select the clips to transfer by selecting the main menu → [CLIP] → [COPY] → [FTP] or [FTP(PROXY)] from the thumbnail screen. The selected clips are registered in the upload list.
Clips are also automatically transferred during recording, playback, and thumbnail display.
The dividing unit of the recording files will become smaller when [SHORT SPLIT] is selected in the main menu → [RECORDING SETUP] → [FILE SPLIT] while the rec during upload function is used, allowing to make the timing to start the clip transfer earlier while recording.
If the network is disconnected during transfer, or the power of the camera is turned off and on again, transfer resumes in clip units.
The dividing unit of the recording files will become smaller when [SHORT SPLIT] is selected in the main menu → [RECORDING SETUP] → [FILE SPLIT], making the number of clips to re-transfer reduced.
Only the recorded clip in the slot 1 is automatically transferred during the simultaneous recording.
Clips of interval recording, loop recording, one-clip recording, and one-shot recording are not automatically transferred.
If the clip is recorded after selecting the main menu → [RECORDING SETUP] → [FILE SPLIT] → [ONE FILE], the clip that exceeds approximately 4 GB per file cannot be transferred to the FTP server.
While the rec during upload function is enabled, the streaming function is disabled.
The directory on the FTP server is not listed in the FTP explorer screen during the transmission or waiting to transmit the clips registered in the upload list.
The setting value in the main menu → [NETWORK SETUP] cannot be changed or initialized while the rec during upload function is set enabled.
The copying between the P2 cards will not operate during the transmission or waiting to transmit the clips registered in the upload list.
The clip delete function will not operate during the transmission or waiting to transmit the clips registered in the upload list.
The format function of the P2 card will not operate during the transmission or waiting to transmit the clips registered in the upload list.