Inserting/removing the memory card

Inserting the memory card

The memory card to use with the camera should always be formatted on the camera. (Formatting the memory card)

  • Formatting the memory card will erase all of the recorded data which cannot be restored.


Open the card slot cover.

Insert the memory card into the card slot.

  • Card slot 1 and card slot 2 can each insert one memory card.

  • Insert straight in with the label facing left until it clicks.

    Do not force or apply excess force when inserting the memory card.

Close the card slot cover.

Removing the memory card

Open the card slot cover.

  • Confirm that the card access lamp is not flashing in orange.

  • Data is being written/loaded when the card access lamp is flashing in orange, so do not remove the memory card.

Press in the memory card further into the camera and let go.

  • Pull the memory card straight out when it is released from from the card slot.

Close the card slot cover.

Cautions when using or storing

  • Do not touch the connecting terminal section at the rear of the memory card.

  • Avoid high temperature and humidity.

  • Avoid water droplets.

  • Avoid charging with electricity.

Use or store the memory card with the card inserted into the camera and with the slot cover closed.