- Top
- Picture monitor (PM)
- Information display
- Warning displays
Warning displays
The warning information is displayed when trouble is detected in the unit, camera, or optical fiber multi cable.
- Warning information displayed is cleared when the status returns to normal.
- To manually clear the warning information display, hold down the [CHARA] button of the ROP.
Information displayed
|
Display item |
Description |
|---|---|
|
CAM RCV LVL NG |
The level of the optical signal received by the camera is low |
|
CCU RCV LVL NG |
The level of the optical signal received by the CCU is low |
|
CAM FAN NG |
Trouble with the cooling fan of the camera |
|
CCU FAN NG |
Trouble with the cooling fan of the CCU |
|
CAM HIGH TEMP |
The temperature of the camera is abnormally high |
|
CCU HIGH TEMP |
The temperature of the CCU is abnormally high If you continue operation even with the message displayed, power supply to the camera may stop as a protective measure. |
|
CAM OVER TEMP |
Due to overheating, the camera turned OFF automatically as a protective measure |
|
OVER LOAD |
The power supply circuit load to the camera exceeded 90% |
|
POWER CONT ERROR |
Trouble with the power supply circuit to the camera |
|
CABLE OPEN |
The optical fiber multi cable is not connected |
|
CABLE SHORT |
Power supply to the camera will stop as a protective measure. Turn the unit off immediately, and determine and resolve the problem before turning it back on.
|
|
FORMAT NG |
The CAM mode and CCU mode do not match. |
|
During data transfer (CAM←→ROP) |
Data transfer between the camera and ROP is in progress. |