Cases indicated by error codes

Error code

Display

Description

Behavior and cause

[E-30]

[TURN POWER OFF]

An error occurred in the camera built-in memory because the P2 card being accessed was ejected.

  • Warning lamp flashes four times per second.

  • Cannot operate.

  • Follow the message to turn off the power once and turn on the power again.

  • Ensure that there is no error in the clips on the ejected card, and restore the clips as necessary.

[E-31]

[TURN POWER OFF]

System mode error occurred.

  • Warning lamp flashes four times per second.

  • Cannot operate.

  • Follow the message to turn off the power once, turn on the power again, and check that there is no error display.

[E-33]

[SYSTEM ERROR]

Camera unit error occurred.

  • Warning lamp flashes four times per second.

  • The operation stops.

  • Contact your dealer.

[E-35]

[SYSTEM ERROR]

Codec control error occurred.

  • Warning lamp flashes four times per second.

  • The operation stops.

  • Contact your dealer.

[E-36]

[SYSTEM ERROR]

P2 system error occurred.

  • Warning lamp flashes four times per second.

  • The operation stops.

  • Contact your dealer.

[E-37]

[SYSTEM ERROR]

P2CS microcomputer error occurred.

  • Warning lamp flashes four times per second.

  • The operation stops.

  • Contact your dealer.

[E-39]

[SYSTEM ERROR]

Video initialization error occurred.

  • Warning lamp flashes four times per second.

  • The operation stops.

  • Contact your dealer.

[E-64]

[SYSTEM ERROR]

(or no display)

Reference signal error occurred.

  • Warning lamp flashes four times per second.

  • The operation stops.

  • Contact your dealer.

[E-65]

[No Camera Module Detected]

The camera module cannot be recognized.

  • Warning lamp flashes four times per second.

  • The operation will stop.

  • Contact your dealer.

[E-67]

[Check Camera Module Connection]

There is a connection error between the camera module and the recording module.

  • Warning lamp flashes four times per second.

  • The operation will stop.

  • Confirm if the cable connectors are connected correctly when the extension module is used.

  • Contact your dealer.