SmartUI display ([HOME] screen)

smart_UI_parts

  1. Media remaining space indicator bar

    Displays the remaining free space in the P2 card using a 7-segment display.

    Each segment is equivalent to three minutes, and the decreasing P2 card remaining time is indicated by the segments going out one segment at a time.

  2. Battery charge level indicator bar

    When a battery with a digital indication (% indication) is used, all seven segments up to the F position light if the battery charge level is 70% or higher.

    When the battery charge level falls below 70%, the segments go out one by one for each 10% drop.

  3. Audio channel level meter

    One segment indicates 2 dB increment, with the smallest indication being −34 dB and the [OVER] indication displayed by r at the topmost position.

    Each time you press the <MONITOR SEL> button, it switches between [CH1]/[CH2], stereo, [CH3]/[CH4], and the channel display of the level meter is switched along with it. ([AUDIO] screen)

    Channels output to the monitor audio are displayed in white dropout.

    When the stereo is selected, both channels are displayed in white dropout.

  4. Time code indications

    Each time you press the <COUNTER> button, the display changes in the order of [COUNTER]/[CLIP] → [TCG[R]] → [UBG[R]] → [VUBG[R]] → [COUNTER]/[CLIP] (not displayed in viewfinder)* → [COUNTER]/[CLIP].

    The time code on the viewfinder is not displayed.

    [COUNTER]/[CLIP]: Displays the counter in hours:minutes:seconds. When [TOTAL] is selected from the main menu → [DISPLAY SETUP] → [REC COUNTER], [COUNTER] is displayed. When [CLIP] is selected, [CLIP] is displayed.

    [TCG[R]]: Displays the time code value in hours:minutes:seconds:frame.

    [UBG[R]]: Displays the user bits value.

    [VUBG[R]]: Displays the user bits value of VITC.

    [NDF]: Indicates when the time code is in the non-drop frame mode.

    [DF]: Indicates when the time code is in the drop frame mode.

    [HOLD]: Indicates when the time code generator/reader value is held.

    [F-RUN]: Indicates when the time code is set to advance continuously regardless of the recording operation.

    [R-RUN]: Indicates when the time code is set to advance only during recording.

    [SLAVE]: Indicates when the time code is externally locked.

  5. Recording mode display

    [REC]: Standard recording

    [P-REC]: Pre-recording

    [I-REC]: Interval recording

    [L-REC]: Loop recording

    [S-REC]: Simultaneous recording

  6. Status information

    Audio level display: Indicates whether audio [CH1]/[CH3] or [CH2]/[CH4] audio volume and audio level are in auto adjustment mode. In the auto adjustment mode, [A] is displayed.

    Audio input: Indicates audio [CH1], [CH2], [CH3], and [CH4] input settings.

    When USB connected: Indicates when the main menu → [NETWORK SETUP] → [USB MODE] is set to [ON] and the device selected using [USB MODE SELECT] is connected.

    • In the USB host mode: [USB STORAGE CONNECTED]/[USB STORAGE DISCONNECTED]

    • In the USB device mode: [USB DEVICE CONNECTED]/[USB DEVICE DISCONNECTED]

    Error, card warning display: Indicates the error code when something has caused an error in the camera.