Error displays about proxy data recordings

If an error occurs during recording the proxy data, check the entries in the following table and take necessary actions.

Error displays

(Viewfinder)

Behavior and cause

Action to take

[PROXY ERROR] or [PROXY REC WARNING]

Stops recording of proxy data. This may also stop recording of materials.

  • An error occurred in the internal proxy module.

    [PROXY ERROR]

  • A proxy data recording error occurred.

    [PROXY REC WARNING]

  • If a proxy data recording error occurs, the proxy data currently being recorded will be processed as below:

    • The proxy data being recorded to the P2 card will be deleted.

    • The proxy data being recorded to the SD memory card will not be restored.

The proxy data will not be properly recorded. Turn off the camera and turn on it again to check the recording and playback. If the error continues to occur, please consult your dealer.

[SD 0 min]

Recording of the materials and proxy data will continue.

  • The remaining SD memory card capacity is getting low. (approximately shorter than one minute)

After finishing recording, insert a new SD memory card.

[SD END]

Proxy data recording to the SD memory card will stop, but recording to the P2 card will continue.

  • No SD memory card capacity remains.

After finishing recording, insert a new SD memory card.

  • The proxy data being recorded to the SD memory card will be deleted.

To restore the deleted proxy data, select clips in the P2 card and copy them to the SD memory card. (Copying proxy data to the SD memory card)

[SD WR ERR]

Proxy data recording to the SD memory card will stop, but recording to the P2 card will continue.

This is displayed when proxy data cannot be recorded in the SD memory card even when the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [CODEC USAGE] is set to [PROXY REC(P2&SD)].

Check the status of the SD memory card and insert a recordable card. (Checking the SD memory card)

[SD --min] or [SD WP]

Proxy data will not be recorded to the SD memory card, but recording to the P2 card will be performed.

  • No SD memory card is inserted. [SD --min]

  • The SD memory card is write-protected. [SD WP]

Check the status of the SD memory card.

Copying proxy data to the SD memory card

Press the <THUMBNAIL> button to display the thumbnail screen.

Use the cursor buttons to move the cursor to the clip to be copied, and press the <SET> button.

Select [SD CARD] in the main menu → [CLIP] → [COPY].

Select [YES] in the confirmation message and press the <SET> button.