Adjusting the white balance

The white balance must be adjusted again when the lighting conditions change. Follow the steps below to adjust the white balance automatically.

When you have no time to adjust the white balance

  • Set the <WHITE BAL> switch to <PRST>.

    The value can be changed to 3200 K, 5600 K, or the user-specified variable value by pushing the <AUTO W/B BAL> switch towards the <AWB> side, and while the color temperature is displayed, pushing the <AUTO W/B BAL> switch towards the <AWB> side again. The variable value can be changed with the jog dial button while the color temperature indication [V****K] at the bottom of the screen is highlighted. At this time, if the jog dial button is turned while pressing, the setting value can be changed faster. Highlight disappears in several seconds if the setting is not changed.

When the white balance has not been automatically adjusted

  • When the auto tracking white balance (ATW) function is operating, white balance cannot be adjusted.

  • When the white balance has not been successfully adjusted, the viewfinder displays an error message.

Error message

Meaning

Remedy

[AWB Ach NG] or [AWB Bch NG]

The color temperature is too high, or too low.

Select the appropriate filter.

[LOW LIGHT]

There is insufficient light.

Increase the amount of light or increase gain.

[LEVEL OVER]

There is too much light.

Decrease the amount of light or decrease gain.

[COLOR TEMP LOW] or [COLOR TEMP HIGH]

The color temperature is too high, or too low.

Select the appropriate filter or light source.

Manual setting of color temperature

The color temperature of white balance can be adjusted by the setting menu.

Set the color temperature in the main menu → [SW MODE] → [W.BAL VAR].

This can be set from [2000K] to [15000K].

Setting the auto tracking white balance (ATW) function

The camera is equipped with the Auto Tracking White Balance (ATW) function that automatically tracks the white balance of images according to the lighting conditions.

The auto tracking white balance function can be assigned to <B> of the <WHITE BAL> switch. Configure the settings in the main menu → [SW MODE] → [ATW].

Note that if the auto tracking white balance function is assigned to the USER button, the function follows the operation of the USER button.

For details, refer to “Assigning functions to USER buttons”.

Canceling the auto tracking white balance

Press the USER button to which auto tracking white balance function is assigned again or change the position of the <WHITE BAL> switch. Note that if the auto tracking white balance function is set to the <WHITE BAL> switch, the function cannot be canceled with the USER button.