- Top
- Shooting
- Streaming function
- Using the streaming function
Using the streaming function
After you finish configuring the network connection, you can configure the streaming function.
Select [STREAMING] in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [CODEC USAGE].
Streaming function is enabled.
Set the streaming mode in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [STREAMING MODE].
Select either [LOW], [HQ], [AVC-G6], [SHQ (QoS)], or [AVC-G (QoS)].
For details on combinations of system modes and streaming modes, refer to the table in “List of system modes and supported streaming output”.
Set the method for starting streaming.
When starting streaming through operation from an application software
Select [RECEIVER] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START TRIGGER].
When starting streaming through operation from the camera
Select [CAMERA] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START TRIGGER].
Perform following settings when the streaming mode is set to [SHQ (QoS)] or [AVC-G (QoS)] in Step 2.
Set the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [QoS MAX RATE] and [QoS MIN RATE].
Set the delay mode during streaming in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [STREAMING LATENCY]. [NORMAL] is set when the stability of streaming is to be prioritized. [SHORT] is set when reducing of the streaming delay is to be prioritized.
Start streaming.
When starting streaming through operation from an application software
If you started streaming using an application software, the camera starts the transmission of streaming video.
When starting streaming through operation from the camera
Select [ON] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START].
The transmission of streaming video is started when the camera is connected to to the transmission destination via network.
To stop the transmission of streaming video, select [OFF] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START].
Starting and stopping the transmission of streaming video can be switched using the USER button in which [STREAMING START] is assigned in the main menu → [USER SW]. During recording, switching is disabled.