Recording function that cannot be used simultaneously
Depending on the recording function that is set, there are recording functions that cannot be used simultaneously.
Meaning of the symbols used in the table are as follows.
✓: Can be used simultaneously.
—: Cannot be used simultaneously.
Recording function that is set | |||||
|---|---|---|---|---|---|
Recording function to additionally set | Pre-recording*1*2*3 | Relay recording*3 | Simultaneous recording*3 | Interval recording*3*4*5*6*7*8 | VFR*4*5*6 |
Pre-recording*1*2*3 |
✓ |
✓ |
— |
— | |
Relay recording*3 |
✓ |
— |
— |
✓*9 | |
Simultaneous recording*3 |
✓ |
— |
✓ |
✓*9 | |
Interval recording*3*4*5*6*7*8 |
— |
— |
✓ |
— | |
VFR*4*5*6 |
— |
✓*9 |
✓*9 |
— |
|
Time code is fixed to free run.
The pre-recording is cancelled once when three hours has passed without starting the recording.
When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
Cannot set simultaneously in the following cases.
When recording in AVCHD format
Time code is fixed to recording run.
When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] is set to [50.00i]/[59.94i], this cannot be set.
The time code is fixed to [NDF].
The [OUTPUT SETTINGS] menu → [SDI OUT] → [SDI REC REMOTE] and the [OUTPUT SETTINGS] menu → [HDMI OUT] → [HDMI REC REMOTE] will not operate.
The function will not operate if the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SENSOR MODE] is set to [S35 MIX 2.8K] or [4/3 CROP&MIX 2.2K].