Zebra patterns display

The camera can display two types of zebra patterns.

The zebra pattern can be set in [MENU] → [OUTPUT SETTINGS] → [VF SDI EI ASSIST].

Item

Description of settings

[ZEBRA SW]

Sets if the zebra signal is superimposed or not to the output from the <VF SDI> terminal.

[ON], [OFF]

  • Factory setting: [OFF]

[- ZEBRA1 DETECT]

Sets the detection level of zebra pattern 1.

[0%] - [109%]

  • Factory setting: [80%]

[- ZEBRA2 DETECT]

Sets the detection level of zebra pattern 2.

[0%] - [109%]

  • Factory setting: [100%]

[- ZEBRA2]

Enables/disables zebra pattern 2 and selects [SPOT].

[ON], [SPOT], [OFF]

  • Factory setting: [OFF]

[SPOT]: The image level from the setting value of [- ZEBRA1 DETECT] to the setting value of [- ZEBRA2 DETECT] is displayed in the zebra pattern.

co_other_zebra