- Top
- Network Connection
- Connecting the remote operation panel
- Setting for connection with remote operation panel
Setting for connection with remote operation panel
To connect the remote operation panel via network to set the camera to the remote control mode, configure the settings in the following procedure.
Configure the network settings of the camera.
Set [MENU] → [PERIPHERAL] → [LAN PROPERTY] → [DHCP] to [DISABLE], and set following the Steps 1 to 2 in “Wired LAN settings”.
Set each item in [MENU] → [PERIPHERAL] → [NETWORK FUNC] → [USER ACCOUNT] in the camera.
[USER NAME]: Sets the user account name. (Factory setting: [guest] or [admin])
[PASSWORD]: Sets the password. (Factory setting: [p2guest] (when [USER NAME] is set to [guest]), [12345] (when [USER NAME] is set to [admin]))
Enter up to 31 characters for a user account, and characters between 5 and 15 for a password.
Configure the network settings of the remote operation panel.
For the setting method, refer to the operating instructions of the remote operation panel.
For the AK-HRP200G network setting, use the supplied ROP setup software application.