Wired LAN settings

The settings to connect to computers using the wired LAN are as follows.

Set each item in [MENU] → [PERIPHERAL] → [LAN PROPERTY] as necessary.

[DHCP] and [DHCP SERVER] are mutually exclusive.

[MAC ADDRESS]:MAC address of wired LAN (cannot be changed)

[DHCP]: Setting whether to use automatic acquisition via DHCP ([ENABLE]: Use automatic acquisition/[DISABLE]: Does not use automatic acquisition (Factory setting: [ENABLE])

[IP ADDRESS]: IP address (Factory setting: [192.168.0.1]) (cannot be set when [DHCP] is set to [ENABLE])

[SUBNET MASK]: Subnet mask (Factory setting: [255.255.255.0]) (cannot set when [DHCP] is set to [ENABLE])

[DEFAULT GATEWAY]: Default gateway (Factory setting: [192.168.0.254]) (cannot be set when [DHCP] is set to [ENABLE])

[PRIMARY DNS]: Primary DNS server setting (Factory setting: [0.0.0.0])

[SECONDARY DNS]: Secondary DNS server setting (Factory setting: [0.0.0.0])

[DHCP SERVER]: DHCP SERVERSetting whether to use the function ([ENABLE]: Use the DHCP SERVER function/[DISABLE]: Do not use the DHCP SERVER function) (Factory setting: [DISABLE]) (cannot set when [DHCP] is set to [ENABLE])

Select [LAN] in [MENU] → [PERIPHERAL] → [NETWORK SEL].

Configure the settings of wired LAN of your computer.

(For Windows)

Display [Properties] in [Internet Protocol Version 4 (TCP/IPv4)] and configure the settings. For details on how to display the screen, refer to [Start] → [Help and Support].

  • When [DHCP SERVER] is set to [ENABLE] on the camera

    Select [Obtain an IP address automatically] and [Obtain DNS server address automatically] in the [General] tab. Select [Automatic private IP address] in the [Alternate Configuration] tab.

  • When [DHCP SERVER] is set to [DISABLE] on the camera

    Select [Use the following IP address] in the [General] tab.

    • [IP address]: Enter a separate IP address in the same network with the camera.

    • [Subnet mask]: Enter the same value as that of the camera.

    • [Default gateway]: Enter the same address as that of the camera.

    • [Preferred DNS server]/[Alternate DNS server]: Not necessarily to be entered.

(For Mac OS)

  • When [DHCP SERVER] is set to [ENABLE] on the camera

    [Configure IPv4]: Select [Using DHCP].

    [Configure IPv6]: Select [Automatically].

  • When [DHCP SERVER] is set to [DISABLE] on the camera

    [Configure IPv4]: Select [Manually] and enter the following items.

    • [IP Address]

    • [Subnet Mask]

    • Entering [Router] is not required. Leave it blank.

    [Configure IPv6]: Select [Automatically].