Operating Instructions AJ-PX5100G
When the <DISPLAY> switch is set to <CTL>, the CTL counter value appears in the time counter display in the status display. The counter value is ±12-hour display. Besides the time code, drop frame and non-drop frame can be set in the main menu → [REC/PB] → [TC/UB] → [DF MODE]. The playback order of clips recorded to P2 cards is not linear such as with VTR. Each time that thumbnail operation is performed or that some of the P2 cards are re-inserted, the counter value will be re-organized and the positioning of the clips recorded so far will change. Accordingly, in the recording and playback modes, separate counter values are displayed.
In the recording mode (record, recording pause, stop, and recording check), the recording CTL counter value is displayed and counting is performed continuously from the previous recording end point. The CTL counter value is held even if the camera is turned off. Counting is continued from the previous value when the camera is next turned on.
In the playback mode (playback, fast-forward, cue, playback paused), the playback CTL counter value is displayed. For the playback CTL counter value, each time that the playback order of the clip is changed (clip is sorted in recording date and time order), the playback CTL counter value so far is disabled, and is re-calculated referenced to the start frame of the initial clip and displayed again. (Fig. 1)
The clip playback order is changed in the following cases:
When a clip is deleted, copied or repaired, or a P2 card is formatted
When the thumbnail display is switched (For details, refer to “Thumbnail screen display settings”.)
When a P2 card is inserted or removed
The reference value (value of start frame of initial clip) is changed in the following cases:
When the power is turned on or all P2 cards are removed, the top frame becomes 0.
When the playback CTL counter value is reset, the current playback position is taken as 0, and the location that was the reference location becomes a minus number value. (Fig. 2)