Copying clips

Selected clips can be copied to a P2 card or a connected USB storage device in the desired slot.

Use the cursor buttons to move the cursor over the clip to be copied, and press the <SET> button to select the clip.

In the main menu → [CLIP], move the cursor from the [COPY] list over the destination and press the <SET> button.

When multiple clips are selected, the number of selected clips is displayed after pressing the <SET> button.
If the copy destination is a storage device, select the copy destination properties.

Move the cursor to [YES] in the confirmation message and press the <SET> button.

This starts copying of the clip.

When the completion message appears, press the <SET> button.

NOTE

When recording of a clip by linking to the previous clip is possible in one-clip recording ([1CLIP] is displayed), you cannot copy clips. Close the menu once, press and hold the <STOP> button for approx. 2 seconds to end linking of clips, and then try the operation again.
Turning off the power or inserting/removing a card during copying may damage the P2 card. If you accidentally make these mistakes, it can result in defective clips. After deleting the defective clips redo copying.
Copying is not performed when the following error messages are displayed.
- [LACK OF CAPACITY!]
  Copying could not be performed because the recording capacity of the copy destination is insufficient.
- [UNKNOWN CONTENTS FORMAT!]
  Copying could not be performed because a defective clip is selected.
- [NO COPY TO SAME CARD!]
  Copying could not be performed because you are attempting to copy to the same card.
- [TOO MANY CLIPS!]
  Copying could not be performed because there are too many clips selected.
If copying is performed while a text memo is selected in the lower part of the text memo, the section between the selected text memo position and the next text memo will be copied. If no text memo is found after the selected one, then the part after the selected text memo to the end of the clip will be copied. For details, refer to “Using a text memo to divide a clip and copy the necessary portion”.
To interrupt copying, press <SHIFT> button + <EXIT> button or the <SET> button to cancel the operation. The clip being copied will be deleted from the copy destination.
When identical clips (same [GLOBAL CLIP ID]) exist on the destination, [OVERWRITE?] is displayed. Select [YES] when overwriting the clip, and select [NO] when not overwriting the clip.

Top of the page