- Top
- Shooting
- Selecting audio input and adjusting recording levels
- Selecting audio input signals
Selecting audio input signals
Select the audio signal to be recorded to audio channel 1/2.
Audio channel 3/4 is automatically determined by the <CH1 SELECT> and <CH2 SELECT> settings.
<CH1 SELECT> switch | Subjects recorded on channel 1 | Subjects recorded on channel 3 |
---|---|---|
<INT(L)> | L audio of built-in microphone | Microphone and device connected to <AUDIO INPUT 1> |
<INPUT1> | Microphone and device connected to <AUDIO INPUT 1> | L audio of built-in microphone |
<INPUT2> | Microphone and device connected to <AUDIO INPUT 2> | L audio of built-in microphone |
<CH2 SELECT> switch | Subjects recorded on channel 2 | Subjects recorded on channel 4 |
---|---|---|
<INT(R)> | R audio of built-in microphone | Microphone and device connected to <AUDIO INPUT 2> |
<INPUT1> | Microphone and device connected to <AUDIO INPUT 1> | R audio of built-in microphone |
<INPUT2> | Microphone and device connected to <AUDIO INPUT 2> | R audio of built-in microphone |
You can set the number of audio bits recorded in accordance with the format.
For details, refer to “System modes and recording functions”.
Format | Number of audio bits |
---|---|
[AVC-I100] [AVC-I50] | You can select [24BIT] and [16BIT]. You can select the main menu → [SYSTEM MODE] → [AUDIO SMPL RES]. |
[AVC-I200] [AVC-G50] [AVC-G25] | [24BIT] fixed. |
[AVC-G12] [DVCPRO HD] [DVCPRO50] [DVCPRO] [DV] | [16BIT] fixed. |