Using the streaming function

After you finish configuring the network connection, you can configure the streaming function.

Select [STREAMING] in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [CODEC USAGE].

Streaming function is enabled.

Set the streaming mode in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [STREAMING MODE].

Set the method for starting streaming.

  • When starting streaming through operation from an application software

    • Select [RECEIVER] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START TRIGGER].

  • When starting streaming through operation from the camera

    • Select [CAMERA] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START TRIGGER].

    • Perform following settings when the streaming mode is set to [SHQ (QoS)] or [AVC-G (QoS)] in Step 2.

      Set the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [QoS MAX RATE] and [QoS MIN RATE].

    • Set the delay mode during live streaming in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [STREAMING LATENCY]. Set to [NORMAL] if you want to emphasize the stability of streaming. Set to [SHORT] if you want to emphasize the reduction of streaming delay.

Start streaming.

  • When starting streaming through operation from an application software

    If you started streaming using an application software, the camera starts the transmission of streaming video.

  • When starting streaming through operation from the camera

    Select [ON] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START].

    If the camera is connected to the transmission destination through a network, the camera starts the transmission of streaming video.

    To stop the transmission of streaming video, select [OFF] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START].

    Also, the start and stop of the streaming image distribution can be controlled by the USER button when [STREAMING START] is assigned to the USER button with the main menu → [USER SW].