Configure these items to make settings for reading/writing, initialization of user file data on the internal memory, and the camera settings.
Description of settings
Loads/saves/initializes user files on the camera memory.
[LOAD]: Loads user files.
[SAVE]: Saves user files.
[INITIALIZE]: Restores user files to the factory settings.
Selects whether to light the access LED of the P2 card.
Sets up the tally lamp lighting conditions.
[FRONT]: The front tally lamp lights up.
[REAR]: The rear tally lamp lights up.
[BOTH]: Both the front and rear tally lamps light up.
[OFF]: The tally lamp does not light up.
Sets the built-in calendar (date and time) and time zone.
For GMT, set using 30 minute intervals from −12:00 to +13:00 (however, +12:45 is possible). After setting the time, when changing the setting value for [TIME ZONE], the displayed and registered times switch to the time with the time difference.
When in HD (1080i, 720P) mode, selects the output signal of phase to be locked to the signal input to the <GENLOCK IN/VIDEO OUT> terminal.
[HD SDI]: Locks the HD SDI output signal to genlock input.
[COMPOSITE]: Locks the down-converted composite output signals (signal from the <GENLOCK IN/VIDEO OUT> terminal and 480i, 576i signals from the <SDI OUT> terminal) to genlock input.
Adjusts the horizontal phase when the phase is to be locked to the signal input to the <GENLOCK IN/VIDEO OUT> terminal.
[SEEK POS SEL]
Selects the position to move when the <>/<> button is pressed while playback is paused.
[CLIP]: Top of the clip
[CLIP&TEXT MEMO]: Top of the clip and text memo location
Configures internal GPS settings.
[ON]: Activates the GPS operation. Outputs the location information as a signal to the <SDI OUT> terminal and records it as clip metadata.
[OFF]: Does not activate the GPS operation. Does not output and record the location information.
[P.OFF GPS DATA]
Retains the GPS location information when the camera is turned off. Sets whether to record the retained data at the next turning on until a positioning is performed.
[HOLD]: Retains and records data.
[CLEAR]: Clears the data at the time when the camera is turned off. Records 0 (No-Info) at the next turning on until a positioning is performed.
Restores the whole setting menu including all scene files (1 to 6) and user files to the factory settings.